Sears 71668 Range User Manual


 
STEP !0
Installing the Anti-Tip Device
WARNING:
Range must be secured with an approved Anti-
Tip device_
Unless properly installed, the range could be
tipped by you or a child standing, sitting or
leaning on an open door.
AFter installing the Anti-Tip device, verify that it
is in place by carefully attempting to tilt the range
forward.
This range has been designed to meet all recognized
industry tip standards for all normal conditions°
The use of this device does not preclude tipping
of the range when not properly installed.
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB02X7909o
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
...._ _>_'_Anti-Tip l
"_.¢'_ !_]] device [
head '_i__ 'LIII
1
Approx. 20 °. _ I
7 2¼'
"" (8,4 era) .,,," Marked edge of range
2. Locate the outside edge of the device 2W' (5,4 cm)
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, mark the position of
the hole for the screw.
4. For wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal A nail or awl may
be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need a
1t4" x 1_" lag bolt and a 112" O.D. sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware,
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must
be properly tightened as recommended for the hardware.
Wallboard
Anti-Tip
device
Wood screw
Back of range
5. Slide the range against the walt, and check for
prope_ installation by grasping the front edges of the
rear surface unit openings and carefully attempting
to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL OF THE CONTROLS ARE
LEFT IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND "vENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
Converting to LP gas
(or converting back to natural gas from LP)
This range leaves the factory set for use with natural
gas, If you want to convert to IP gas, the conversion
must be performed by a qualified LP gas insta!lero
The conversion instructions, sticker and LP orifices
can be found attached to the range next to the pressure
regtflator.
There is a second set of instructions included in the
envelope containing the product wiring diagrams on
the back of the range_ Keep these instructions and the
orifices in case you want to convert back to natural gas_
39