Filter
Top Products
Installation
Check the oven model number plate to see if the oven is
approved for installation in mobile homes and/or
recreational vehicles. If approved the following items are
applicable. NOTE: Oven model number plate is located
under broiler bottom.
Mobile Homes
The installation of an oven designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24 HUD, (Part 280) or,
when such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI A225.1/NFPA
501A, or with local codes.
In Canada the range must be installed in accordance with
the current CSA Standard C22.1 - Canadian Electrical
Code Part 1 and Section Z240.4.1 - Installation
Requirements for Gas Burning Appliances in Mobile
Homes (CSA Standard CAN/CSA - Z240MH).
Recreational Vehicles
The installation of an oven designed for recreational
vehicles must conform with state or other codes or, in the
absence of such codes, with the Standard for
Recreational Vehicles, ANSI A119.2-latest edition.
In Canada the oven must be installed in accordance with
CAN/CSA - Z240.6.2 - Electrical Requirements for R.V.'s
(CSA Standard CAN/CSA - Z240 RV Series) and Section
Z240.4.2 - Installation Requirements for Propane
Appliances and Equipment in R.V.'s (CSA Standard
CAN/CSA - Z240 RV Series).
Locating The Unit
The installation diagram gives the minimum dimensions of
the cabinet cut-out for the oven. The dimensions given
are for the oven bottom to be a minimum of 14" inches
above the floor. The recess in which the oven is to be
installed should have a solid floor and be so constructed
as to provide a complete enclosure around the recessed
portion of the oven to prevent drafts which may result in
inconsistent and unsatisfactory burner and baking
performance, it should be perfectly level to provide a
solid, level foundation for the oven unit. The openings in
the enclosure for gas and electric service should be
sealed before the oven is installed.
For SAFETY CONSIDERATIONS fasten the oven to the
cabinet with the four (4) screws (shipped with the unit)
through the holes in the trim behind the oven and broiler
doors. The unit should be leveled properly before being
secured to the cabinet.
Electric Supply
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code,
ANSI/NFPA 70.
In Canada the oven must be installed in accordance with
the current CSA Standard C22.1 - Canadian Electrical
Code Part 1.
ELECTRICAL SUPPLY CONNECTION:
The oven requires 120 volts, 60 cycle alternating current
from an outlet capable of supplying 15 amperes.
User may experience occasional circuit tripping if Ground
Fault Circuit Interrupter (GFCl) outlet or breaker is in use.
, WARNING
Electrical Grounding Instructions
This appliance is equipped with a (three-prong)
grounding plug for your protection against shock
hazard and should be plugged directly into a
properly grounded receptacle. Do not cut or remove
the grounding prong from this plug.
I WARNING
DISCONNECT ELECTRICAL SUPPLY
BEFORE SERVICING THE APPLIANCE.
-3-