Filter
Top Products
IMPORTANTINSTRUCTIONSFOR YOURSAFETY
• Injury To Persons Could i_!i_i
Result _i_iiiii
• Install Anti-tip Device _
Packed+ithRange
• See Installation Instructions
a
1
Tools you will need:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
1. Remove the bracket from the prepack
located inside the oven.
2. Decide whetherthe bracketwill be installed
on the right or left side of range location.
3. If the bracket side of the range is adjacent
to a cabinet, place the bracket against
back wall and cabinet as shown below.
ADJACENT CABINETOR FINAL
LOCATION OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
ACKET TO BE
FLUSH WITH LEFt OR
RIGHT SIDE OF RANGE
N
WALL BEHIND
RANGE1
m
w
If there is no adjacent cabinet, determine
where the location of the range side (painted
outside panel) will be. Place the bracket
with its outside edge at this location and
against back wall. See illustration below.
Determine whether you will anchor the
bracket to the floor or waft. Make sure this
location is clear of electrical wiring or
plumbing.
Fasten the bracket securely with the screws
provided. Screws are selFdrilling in wood,
plywood, particle and chip board, and
most metal framing. If attaching to
masonry, you can buy suitable screws and
anchors at hardware stores. Use amasonry
drill to drill the required holes.
BRACKET
SCREW MUST ENTER_
WOOD OR METAL |
illlllP*,**L*lbl..,i _tll
WALL
PLATE
/
ATTACHMENT TO WALL
Using the wrench, back out the four leg
levelers at least two turns. See your
installation guide for more leveling
information before positioning range.
Slide the range into place. Be sure rear leg
levelerfullyengagestheslotinthebrackeL If
range cannot be moved back far enough
for rear leg leveler to enter bracket, move
bracket forward as required and attach to
floor in new location.
3