Filter
Top Products
25
Recommendations and tips
... for the plug-on transmitter
y Use microphones with a metal casing, since the
transmitter uses the microphone body as an antenna.
y You can vary the bass reproduction by increasing/
decreasing the talking distance.
y For best results, make sure that the transmitter
sensitivity is correctly adjusted.
... for optimum reception
y Transmission range depends to a large extent on location
and can vary from about 10 m to about 150 m. There
should be a “free line of sight” between transmitting and
receiving antennas.
y To avoid overmodulating the receiver, observe a
minimum distance of 5 m between transmitting and
receiving antennas.
... for multi-channel operation
y For multi-channel operation, you can only use the
channels in a channel bank. Each of the channel banks “1”
to “8” accommodates up to 20 factory-preset
frequencies
which are intermodulation-free. For alternative
frequency
combinations, please refer to the enclosed frequency
table. The freely selectable frequencies can be selected
via the “TUNE” menu and can be stored in the channel
bank “U”.
y When using several transmitters simultaneously,
interference can be avoided by maintaining a minimum
distance of 20 cm between two transmitters.
Care and maintenance
Use a slightly damp cloth to clean the transmitter from time
to time.
Note:
Do not use any cleansing agents or solvents.