Filter
Top Products
23
Due to technical error, contact a service centre approved
by SHARP.
1. The sensor does not detect vapor properly in microwave
sensor mode.
2.
Oven door is opened or Stop/Clear is pressed during sensing.
For both 1 and 2, press Stop/Clear and cook manually.
1.
The time you set is over the maximum time for Steam Cook
High or Steam Cook Low. Press Stop/Clear and re-program.
2. The time of day you enter is incorrect. This is 12 hour
clock. Press the Stop/Clear and reprogram.
The weight or quantity you enter is more or less than the
allowed amount as indicated in the cooking charts. Press
the Stop/Clear and re-program.
The oven is too hot to use for Steam Defrost, Easy Defrost
or Steam Cook Low. Remove food from oven and allow to
cool until the message clears.
Remove water tank and fi ll with water to the MAX mark.
Replace and push fi rmly into place, then press Stop/Clear
to clear the error message.
Make sure that the water tank is fi lled to the MAX mark
with room temperature water suitable for drinking (fi ltered).
To continue the cooking, cook manually. Check for
doneness from time to time.
NOTES:
1. Ensure you do not use any other liquids like distilled
water, mineral water and etc.
2. When this error message appears again and again
even if you fill the water tank with water, the internal
steam system may be out of order. Contact a service
centre approved by SHARP. You can use the oven for
the cooking modes which do not use steam.
The water in the internal steam system is frozen.
Operate the oven with Grill without food for 10 minutes.
See page 17.
Follow step-by-step instructions for descaling.
See page 10.
The oven cabinet and oven cavity are very hot.
Pay extra attention not to burn yourself.
This message is not a sign that the oven is malfunctioning.
When the setting of Energy Save Mode is completed, “SV”
will appear on the display. Then the display will show “ . 0”
for 3 minutes before the oven power is off. See page 21.
If EE is displayed or you think the oven is not working properly, check the chart below before consulting a
service centre approved by SHARP. This will help to prevent unnecessary service calls.
TECHNICAL ERROR MESSAGE / INFORMATION MESSAGE
TECHNICAL
ERROR MESSAGE
SENSOR
ERROR
INFORMATION
MESSAGE
EE
Err, SENSOR (fl ashing)
Err
Err, AUTO, DEF*, KG
(fl ashing), QTY (fl ashing)
Err, HOT (fl ashing)
Err, WATER (fl ashing)
COLd
DESCALE (fl ashing)
HOT (fl ashing)
SV
MESSAGE ON DISPLAY ACTION
WARNING:
Never adjust, repair or modify the oven by yourself. It is hazardous for anyone other than a qualifi ed
service technician trained by SHARP to carry out any service or repair operation. This is important
as it may involve the removal of covers that provide protection against electrical parts.
• Repairs and Modifi cations: Do not attempt to operate the oven if it is not working properly.
•
Outer cabinet: Never remove the outer cabinet to avoid the possibility of electrical shocks or burns.
* (DEF is on the display at Steam
Defrost and Easy Defrost mode)
TROUBLESHOOTING CHART
Troubleshooting Chart