Filter
Top Products
38
TROUBLESHOOTING CHART
Due to technical error, call service for your nearest Sharp
Authorized Servicer.
The sensor does not detect vapor properly in microwave
sensor mode. Press Stop/Clear and finish cooking using
manual time.
The oven is too hot to use Microwave Defrost or Steam Proof.
Remove food from oven and allow to cool until the message
clears.
The oven may not operate properly.
Operate the oven with Convection Broil without food and
preheat for 5 minutes.
See page 29.
After cooking, the oven and the parts will be hot.
Now cooling is shown in the display until the oven cavity
has cooled. The cooling fan may continue to operate up to
13 minutes.
Now cooling will disappear when the oven has cooled.
If you wish to use the warm oven, simply press Stop/Clear.
Remove and replace the drip tray correctly.
See page 13.
In case the drip tray is not installed correctly, Replace drip
tray will be shown in the display.
Empty drip tray and replace will be shown in the display
when water remains in the drip tray. You must empty the drip
tray and replace it before SuperSteam Convection or Steam
Cooking will start. See page 13.
Follow step-by-step instructions for descaling.
See page 15.
Remove reservoir and fill with water to the 2 mark.
Replace and push firmly into place.
The oven cabinet and oven cavity are very hot.
Pay extra attention not to burn yourself.
If EE is displayed or you think the oven is not working properly, check the chart below before consulting a Sharp
Authorized Servicer. This will help to prevent unnecessary service calls.
TROUBLESHOOTING CHART
ERROR MESSAGE / INFORMATION MESSAGE
ERROR
MESSAGE
SENSOR
ERROR
INFORMATION
MESSAGE
EE
Finish cooking by time.
Press Clear.
Wait.
Oven is too warm to use.
Water is frozen.
Now cooling.
Replace drip tray.
Empty drip tray and replace.
Descaling is necessary.
Fill water reservoir.
Hot
MESSAGE ON DISPLAY ACTION