Filter
Top Products
4
INSTALLATION MANUAL
MODEL AND SERIAL NUMBER LOCATION
The name plate, including model and serial number, is located
on the faceplate behind the Microwave Drawer front.
CARE, CLEANING AND MAINTENANCE
Refer to the Operation Manual for cleaning instructions.
BEFORE YOU CALL FOR SERVICE
Read the BEFORE YOU CALL and operating instruction sections
in your Operation Manual. It may save you time and expense.
The list includes common occurrences that are not the result of
defective workmanship or materials in this range.
Refer to the warranty in your Operation Manual for Sharpʼs
toll-free service number and address. Please call or write if you
have inquiries about your microwave product and/or need to
order parts.
PRINTED IN USA
TINSEB417MRR0
SHARP ELECTRONICS CORPORATION
S
harp
P
laza,
M
ahwah,
N
ew
J
ersey 07430-2135
4 Screws
Parts Supplied
DRAWER INSTALLATION
1. Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply cord
into the electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between
the oven and the wall.
3. Slide the drawer all the way until the mounting fl ange is fl ush
with the face of the cabinet.
4. Secure the drawer with the 4 screws supplied. See Figure 6.
Figure 6
ELECTRICAL OUTLET
4"
5"
electrical outlet location
2x4 Anti-
Tip block
(6")
The electrical requirements are a 120 volt 60 Hz, AC only, 15
amp. or more protected electrical supply. It is recommended that
a separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug. It must
be plugged into a wall receptacle that is properly installed and
grounded. Should you only have a 2-prong outlet, have a qualifi ed
electrician install a correct wall receptacle.
Note:
If you have any questions about the grounding or electrical
instructions, consult a qualifi ed electrician or service person.
Figure 5
GROUNDING INSTRUCTIONS
This appliance must be grounded. The Microwave Drawer is
equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded in accordance with the National
Electrical Code and local codes
and ordinances. In the event
of an electrical short circuit,
grounding reduces risk of
electric shock by providing
an escape wire for the electric
current.
– Improper use
of the grounding plug can result
in a risk of electric shock.
3-Prong Plug
Grounding Pin
3-Prong Receptacle
Ground Receptacle Box
Permanent and Correct Installation
Grounding Adapter
Ground Receptacle Box
Screw
Tab for Grounding Screw
Temporary Use