Filter
Top Products
10
SEC R55TS
TINSEA983WRRZ-D32 SEC R55TS
PROCEDURE DISPLAY
• If the electrical power supply to your microwave oven
should be interrupted, the display will intermittently
show
88:88
after the power is reinstated. If this oc-
curs during cooking, the program will be erased. The
time of day will also be erased. Simply touch STOP/
CLEAR and reset the clock for the correct time of day.
00 (hour) will flash.
BEFORE OPERATING
• Before operating your new toaster oven with micro-
wave make sure you read and understand this opera-
tion manual completely.
• Before the oven can be used, follow these procedures:
1. Plug in the oven. Close the door. The oven display
will begin flashing
88:88
.
2. Touch STOP/CLEAR.
will appear.
3. Set clock. See below.
4. Condition the heaters by heating oven without food.
See page 11.
::
::
:
TO SET THE CLOCK
• Suppose you want to enter the correct time of day 12:30
(A.M. or P.M.).
1
Touch CLOCK.
Enter the correct hour by
rotating the rotary dial.
2
3
Touch CLOCK again.
STOP/CLEAR
Touch STOP/CLEAR to:
1. Erase if you make a mistake during programming.
2. Cancel timer.
3. Stop the oven temporarily during cooking.
4. Return the time of day to the display.
5. Cancel a program during cooking, touch twice.
MANUAL OPERATION
Your oven can be programmed for 95 minutes (95.00)
using the rotary dial. The increments for time entry vary
from 10 seconds to 5 minutes, depending on the total
length of the cooking /defrosting time as shown in the table
below:
MICROWAVE TIME COOKING
PROCEDURE DISPLAY
1
Enter cooking time.
Touch START.
2
There are six preset power levels. Using lower power
levels increases the cooking time, which is recom-
mended for foods such as cheese, milk and long slow
cooking of meats. Consult cookbook or recipes for
specific recommendations.
• Suppose you want to defrost for 5 minutes at 30%.
once 100% High
twice 70% Medium High
3 times 50% Medium
4 times 30% Med Low/Defrost
5 times 10% Low
6 times 0%
PROCEDURE DISPLAY
1
Touch MICRO 4 times or
hold down until the desired
power level appears.
2
3
Enter defrost time.
Touch START.
4
When the defrost time is complete, a long tone
will sound and
will appear in the display.
x 4
Enter the correct minute by
rotating the rotary dial.
Touch CLOCK again.
4
5
• Suppose you want to cook for 5 minutes at 100%.
Cooking Time Time Increments
0-5 minutes 10 seconds
5-10 seconds 30 seconds
10-30 minutes 1 minute
30-95 minutes 5 minutes
TO SET POWER LEVEL
You can program up to 3 cooking sequences.
Follow directions on page 21. Note that the power level
must be entered first when programming multiple sequences.
00 (minute) will flash.
Touch MICRO
Approximate
Percentage of
Power
Commmon Words
for
Power Level
You can turn the rotary dial clockwise or counter-
clockwise. If you turn it counter-clockwise, the cooking
time will decrease from 95 minutes.