Filter
Top Products
17
Disconnect the power cord before cleaning or
leave the door open to inactivate the oven dur-
ing cleaning.
Exterior
The outside surface is painted. Clean the outside with
mild soap and water. Then wipe with a clean damp-
ened cloth and polish dry with a soft cloth. Do not use
any type of household or abrasive cleaner.
Door
Wipe the window on both sides with a soft damp cloth
to remove any spills or spatters. Metal parts will be easier
to maintain if wiped frequently with a soft damp cloth.
Avoid the use of spray and other harsh cleaners as they
may stain, streak or dull the door surface.
Touch Control Panel
Wipe the panel with a soft cloth dampened slightly with
water only. Dry with a soft cloth. Do not scrub or use
any sort of chemical cleaners. Close door and touch
STOP/CLEAR pad.
Interior
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and setting
of spills or spattering. To clean the interior surfaces, wipe
with a soft damp cloth. DO NOT USE ABRASIVE OR
HARSH CLEANERS OR SCOURING PADS. For heavier
soil, use baking soda or a mild soap; wipe clean with a soft
damp cloth. NEVER SPRAY OVEN CLEANERS DI-
RECTLY ONTO ANY PART OF THE OVEN.
Waveguide Cover
The waveguide cover, located on the right wall of the cavity,
is made from mica so requires special care. Keep the
waveguide cover clean to assure good oven performance.
Carefully wipe with a soft damp cloth any food spatters
from the surface of the cover immediately after they occur.
Built-up splashes may overheat and cause smoke or
possibly catch fire. Do not remove the waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the oven.
To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100%
power. Allow to set in oven until cool. Wipe interior with
a soft cloth.
Turntable/ Turntable Support
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and a non-abra-
sive scouring sponge. They are also dishwasher-proof.
The turntable motor shaft is not sealed, so excess wa-
ter or spills should be wiped up immediately.
CLEANING AND CARE
Exterior
Interior
Turntable
Turntable Support
SEC R220_230_209K,P15-20 05.1.27, 10:39 AM17