Filter
Top Products
18
Exterior
Exterior-painted
Clean the outside painted surfaces with mild soap and water. Rinse and
polish dry with a soft cloth. Do not use any type of household or abrasive
cleaner.
Exterior-stainless steel
Clean the stainless steel surfaces with mild soap and water. Rinse and
polish dry with a soft cloth. You may wish to purchase a stainless steel
polish for enhancing the appearance of the stainless steel parts of the
oven exterior. Be sure to follow manufacturer’s directions for the polish.
Never use any type of abrasive cleaner on stainless steel.
Door
Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a damp cloth. Cleaners which are marked specifically for use with stainless steel
may be used with stainless steel model. Follow package directions exactly. Avoid the use of any harsh cleaner as
they may stain, streak or dull the door surface.
Touch Control Panel
Care should be taken in cleaning the touch control panel. If the control panel becomes soiled, wipe the panel with
a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub or use any sort of chemical cleaners.
Close door and touch STOP/CLEAR.
Interior
Cleaning is easy because little heat is generated to the interior
surfaces; therefore, there is no baking and setting of spills or spatter-
ing. To clean the interior surfaces, wipe with a soft cloth and warm
water. DO NOT USE ABRASIVE OR HARSH CLEANERS OR
SCOURING PADS. For heavier soil, use baking soda or a mild soap;
rinse thoroughly with hot water. NEVER SPRAY OVEN CLEAN-
ERS DIRECTLY ONTO ANY PART OF THE OVEN.
Waveguide Cover
The waveguide cover is made from mica so requires special care. Keep the waveguide cover clean to assure
good oven performance. Carefully wipe with a damp cloth any food spatters from the surface of the cover immedi-
ately after they occur. Built-up splashes may overheat and cause smoke or possibly catch fire. Do not remove the
waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel and juice of
1 lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several minutes using 100% power.
Allow to set in oven until cool. Wipe interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed for easy cleaning. Wash them in mild,
sudsy water; for stubborn stains use a mild cleanser and non abrasive scouring sponge.
They are also dishwasher-proof. Use upper rack of dishwasher. The turntable motor shaft is
not sealed, so excess water or spills should be wiped up immediately.
Interior
Turntable Support
CLEANING AND CARE
Turntable
Disconnect the power cord before cleaning or leave the door open to inactivate the oven during cleaning.
1.410/408/405H #339 2/26/03, 10:14 AM18