Sharp SJ-244V Refrigerator User Manual


 
3
WARNING
CAUTION
INSTALLATION
1.
2.
Using the front Adjustable foot, ensure that the
refrigerator is positioned firmly and level on the floor.
3.
Connect the power plug to a 230/240 volt. 10 amp.
power point.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Adjustable
foot
Dust deposited on the power plug may cause fire. Wipe
it off carefully.
Do not attempt to change or modify this refrigerator. This
may result in fire, electric shock or injury.
Ensure that the refrigerator presents no danger to
children while being stored for disposal. (e.g. remove the
door to prevent child entrapment.)
Do not touch the compressor unit or its peripheral parts,
as they become extremely hot during operation and the
metal edges may cause injury.
Do not touch foods or metal containers in the freezer
compartment with your wet hands. This may cause
frostbite.
Do not place bottled and canned drinks in the freezer as
they may crack when frozen.
In case of gas leak, ventilate the area by opening a
window, etc. Do not touch the refrigerator or the power
outlet.
Do not place objects containing liquid or unsteady
objects on top of refrigerator.
This refrigerator is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the refrigerator by a person
responsible for their safety. Young children should be
supervised to ensure that they do not play with the
refrigerator.
WARNING
Do not install the refrigerator in a damp or wet
location as this may cause damage to the
insulation and a leak. Condensation may also
build on the outer cabinet and cause rust.
1.
3.
2.
4.
5.
2.
3.
4.
5.
6.
7.
SJ-244V
970mm
1145mm
1065mm
1221mm
a
b
60mm
90mm
60mm
60mm
Keep adequate ventilation space around the
refrigerator.
The figure shows the minimum required space for
installing the refrigerator. It differs from the space in
the measurement condition of the amount of power
consumption.
SJ-308V
SJ-339V
NOTE :
Position your refrigerator so that the plug is accessible.
Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
Attention about Power supply:
Do not use an extension cord or adapter plug.
Make sure that the power cord has not been damaged
during installation or moving. If the power plug or cord
is loose, do not insert the power plug. There is a risk
of electric shock or fire.
Disconnect from the mains electricity supply by
removing the mains plug from the electricity supply
socket. Do not remove by pulling the mains lead. This
may cause electric shock or fire.
Should the flexible supply cord be damaged, it must
be replaced by service agent approved by SHARP as
a special cord is required.
1.
Insufficient spacing will decrease cooling efficiency
and increase energy consumption.
This may reduce the life of the unit and void warranty.
This refrigerator is designed for indoor use only, do not
place the unit on an unsealed surface.
Do not store highly volatile and flammable materials such
as ether, petrol, propane gas, aerosol cans, adhesive
agents and pure alcohol etc.
These materials are liable to explode.
This refrigerator contains flammable refrigerant (R600a:
isobutane) and insulation blowing gas (cyclopentane).
Observe the following rules to prevent ignition and explosion.
The refrigeration system behind and inside the refrigerator
contains refrigerant. Do not allow any sharp objects to
come into contact with the ref
rigeration system.
Do not use mechanical devices or other means to
accelerate the defrosting process. (This refrigerator has
adopted automatic defrosting system.)
Do not use electric appliances inside the refrigerator.
Use only the specified parts for the refrigerator
compartment light.
Do not block the openings on the circumference of the
refrigerator.
Do not use flammable sprays, such as spray paint near
the refrigerator. It may cause explosion or fire.
If the refrigeration system should get punctured, do not
touch the wall outlet and do not use open flames. Open
the window and air out the room. Then ask a service
agent approved by SHARP for servicing.
This refrigerator should be disposed appropriately.
Take the refrigerator to a recycling plant for flammable
refrigerant and insulation blowing gases.