Filter
Top Products
-\
1.
2.
3.
4.
5.
Remove the shelves and pocketsS4from the cabinet and door. Wash them in warm soapy
dishwashing water; rinse in clean water and dry.
Clean the inside with a cloth soaked in warm soapy dishwashing water.
Then wipe with cold water with a teaspoon of vanilla essence added to remove any odours.
Wipe the exterior with a soft cloth each time it is soiled. It is a good idea to occasionally
polish the exterior with a car type polish to protect the paintwork and make cleaning easier.
Clean Magnetic door seal with a toothbrush and a warm water and household detergent
mixture.
Whenever the refrigerator is moved to clean or reposition, Evaporating pan should be
removed and cleaned.
To remove Evaporating pan;
To set Evaporating pan;
Move the Evaporating pan to the
Set the Evaporating pan so that the two
right and pull it toward yourself.
protrusions on the machine come through its
corresponding holes,and move the pan to the
\I
NOTE
Do not use polishing powder, benzene, hot water etc.
Switching off your refrigerator
if you switch your refrigerator off when you are going away for an extended period, remove
all food, clean the interior thoroughly. Remove the power cord plug from the power socket and
leave both doors open.
Before you call for service, check the following point.
WHEN YOUR REFRIGERATOR DOES NOT WORK
0 Check that the power is switched on and that the plug is correctly connected.
l Check with another appliance or lamp to see if the outlet has electric current.
The fuse may be blown or a circuit breaker tripped.
WHEN THERE IS A NOISE DURING OPERATION
l Cabinet not level.
l Weak or uneven floor.
0 The back of the cabinet touching the wall.
l During automatic defrosting, occasionally, a gurgling sound or the sound of parts expanding
and contracting can be heard, these are quite normal.
IT IS NORMAL that the outside of a cabinet may be hot when touch. The hot pipe is in the
cabinet in order to prevent the dew generation.
IF YOU STILL REQUIRE SERVICE
Refer to your nearest Service centre approved by SHARP.
NOTE Should the flexible supply cord be damaged, it must be replaced by Service centre
approved by SHARP as a special cord is required.
4