Filter
Top Products
4
OPERATION
Controlling temperatures
Hints when making ice
1. Do not over fill the Ice cube trays;
otherwise the ice cubes will be
joined together when frozen
2. When the ice cubes are made, turn
the lever clockwise to empty the ice
into the Ice cube box.
NOTE :
To prevent damage to the Ice cube
box, do not make ice in the Ice cube box.
Deodorizing unit
Defrosting
Deodorizing catalyst is installed on the routes of cold air.
No operation and cleaning are required.
Defrosting is fully automatic due to a unique energy saving
system.
CARE AND CLEANING
1. Remove the shelves and pockets from the cabinet and
door. Wash them in warm soapy dishwashing water;
rinse in clean water and dry.
2. Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
Lever
Ice cube box
WARNING
Unplug the refrigerator first to prevent electric
shock.
Do not splash water directly on the outer cabinet
or the interior. This may lead to rusting and
deterioration of the electrical insulation.
To prevent cracking on inside surfaces and plastic
components, follow these tips.
•
•
Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
•If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
3. Wipe the exterior with a soft cloth each time it is soiled.
4.
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
Extreme ambient temperatures
During periods of extreme ambient temperatures
(e.g. less than 10°C, or more than 35°C)
you may find it necessary to rebalance the freezer and
refrigerator temperature controls accordingly.
Wipe any spills from the refrigerator immediately as acid
or alkaline in the food can cause cracking and staining of
plastic parts.
• FREEZER TEMP. CONTROL regulates the quantity of
cold air to the freezer.
• With FREEZER TEMP. CONTROL set to MAX, you may
need to adjust the REFRIGERATOR TEMP. CONTROL
to balance the temperatures.
• REFRIGERATOR TEMP. CONTROL controls the
compressor running time of the refrigeration system.
• MAX setting will result in colder temperature in both
(refrigerator and freezer) compartments.
If a refrigerator lamp blows
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended
period, the following steps should be taken to reduce the
symptom of mould:
1. Remove all food.
2. Remove the power plug from the power point.
3. Clean and dry the interior thoroughly.
4. Ensure that all the doors are wedged open slightly for
air circulation.
NOTE
• Do not use hot water, household cleaning powders, creams
or spray-on cleaning products, or any other cleaning
products such as mineral turpentine, methylated spirits,
thinners, petrol etc. These may damage your refrigerator
and may void any warranty.
• If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
•
Wipe any spills from the control knob immediately as liquid
ingress can damage the electronics.
• Do not drop objects inside the refrigerator or strike the inner
wall. This may cause the inner surface to crack.
IMPORTANT
The lamp should only be replaced by a service center
approved by SHARP.