Filter
Top Products
4
INSTALLATION
WARNING
■
Do not install the refrigerator in a damp or wet location
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
■Inordertopreventpossibleelectricshock,connect
the receptacle of earth to the earth terminal properly.
1
Keep adequate ventilation space around the refrigerator.
• The gure shows the minimum space required for
installing the refrigerator. (Please note that power
consumption is measured in a different environment)
• By keeping greater space, the refrigerator may be
operated under a less amount of power consumption.
• If using the refrigerator in the smaller space dimension
than the below gure, it may cause the temperature
rise in the unit, loud noise and failure.
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned rmly and at on the oor.
3
Clip the foot cover (supplied inside the refrigerator
compartment) in position in front of the two adjustable
feet.
90mm
or more
60mm
or more
60mm
or more
60mm
or more
1350mm
1300mm
1040mm
SJ-WS363T
SJ-WP363T
SJ-RM323T
NOTE
•
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground.
Provide suitable stand.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe
it off thoroughly with water.
Before transporting
• Wipe up water in the evaporating pan. Before wiping up
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
NOTE
•
Do not bend or damage the ductwork located on the inside of
the evaporating pan. It may cause failure.
When transporting
• The casters allow the refrigerator to move back and forth.
• Carry the refrigerator by holding the handles located on
the rear and the bottom.
When the door is heavy to open
(Only for SJ-WS363T, SJ-WP363T)
Whenonesidedoorisheavy
• When the left side is heavy, lower the right side adjustable
foot.
(Until the opposite side adjustable foot is slightly off-ground.)
• When the right side is heavy, lower the left side adjustable
foot.
Whenbothsidesareheavy
• When the refrigerator is tilted backwards insert a wooden
board (with relatively large width), etc. between the rear of
the refrigerator and the oor to adjust the tilting.
Adjustable
foot
Heavy
Adjustable foot
Footcover
Free standing type
Reversible door
(Only for SJ-RM323T)
It is possible to change the door to left side opening. To
modify the door a REFRIGERATOR HINGE KIT (for left side
opening) will be required, SJ-LR320TD. For details of the kit
and the modication work, please contact the service agent
approved by SHARP.
CAUTION
SHARP recommends that all modication work
will be carried out by the approved service agent.
Evaporating
Pan
Casters
(4pcs.)
A wooden board
(with relatively
large width)
Front Back
(B163)P2-P12_Eng.indd 3 2011/01/18 16:48:42