Filter
Top Products
8 GB/IE
Safety / Before the First Usage / Operation
½ Use the appliance with the supplied accesso-
ries only. No claims under the warranty nor a
liability for damages will be accepted if they re-
sult from improper or incorrect use of the slicer.
©
Before the First Usage
©
First steps
˽ Carefully remove the electric Multi-Purpose
Slicer from its packaging, remove all packag-
ing materials and keep them together with the
main packaging.
˽ Clean the electric Multi-Purpose Slicer before it
comes into contact with any foodstuffs (see also
the chapter ‘Cleaning’).
©
Setting up the appliance
Specific safety advice on the
placing of the appliance
1. Never set the electric Multi-Purpose Slicer up
on a hot surface or near an open flame.
2. Ensure that the power cable
8
does not pass
over hot or sharp-edged objects.
3. Do not allow the power cable
8
to become
kinked or trapped and do not wrap it around
the electric Multi-Purpose Slicer.
˽ Set the electric Multi-Purpose Slicer up on a
flat, non-slip surface close to a power socket.
˽ Unwind the required length of power cable
8
.
Insert the plug into the power socket.
˽ Place the food carriage
10
on the supporting
table with guide slot
9
(see Fig. B). Now
press the on the blade cover
6
high standing
side down, so that the holding clamps (on the
underside of the food carriage
10
) engage. En-
sure that these have correctly engaged, in that
you check the mobility of the food carriage. Pull
to the front for removal of the food carriage
10
from the guide slot
9
and lift it from the sup-
port table
9
.
˽ Push the food holder plate
11
on to the food
carriage
10
.
˽ Place the catch tray
17
below the support
table
9
and on the housing such that the
sliced foods can fall in there directly and with-
out hindrance after being cut.
©
Adjust the infinite slice-thick-
ness setting (see Fig. D)
Through variable tightenings of the adjusting
screws
16
you can determine the movement rate
of the infinite slice-thickness setting
14
.
˽ Screw both of the adjusting screws
16
tight
with the screwdriver
15
.
˽ Check, by turning the infinite slice-thickness
control knob
14
, to see if the desired movement
rate is suitable.
If it is not,
- loosen both adjusting screws
16
for a lighter
movement rate or
- tighten both adjusting screws
16
further for a
stiffer movement rate.
©
Operation
©
Working advice
Specific safety advice for
slicing and for the handling of
the appliance
1. Never touch the cuttingblade
12
when the slic-
er is in operation!
There is a risk of grave personal injury!
2. Always use the food carriage
10
and the food
holder plate
11
.
(Exception: very large pieces of foodstuff).
Press the pieces of food to be sliced forward
using the food holder
11
.
3. Use the slicer only for cutting normal house-
hold foods and not for other purposes. Do not
use the slicer for cutting deep-frozen foods,
bones, foods with large kernels or for the
slicing of still packaged foods.
4. Never use the slicer continuously for more than
10 minutes .