Filter
Top Products
- 6 -
Warning:
Remove the plug from the power source when
emptying the filter
d
. This prevents an unintended
starting of the motor.
When the extracted juices suddenly become thicker,
or when you hear that the motor is running slower,
the filter
d
must be emptied. When you have removed
the fruit pulp/vegetable mash, reassemble the
appliance.
Disassembly of the juice extractor
If you wish to disassemble the juice extractor, e.g.
to clean it, proceed as follows:
1. Remove the power plug from the wall socket
i
.
2. Open the clasps
r
.
3. Remove the housing lid
e
with the stodger
q
.
4. Carefully lift up the juice container
t
. With this,
the filter
d
releases itself from the drive shaft
f
.
You can now take the filter
d
out of the juice
container
t
.
Cleaning and Care
Warning:
ALWAYS remove the power plug from the wall socket
before removing or installing accessories and before
cleaning the appliance. To avoid blockage of the
juice outlet and/or damage to the appliance, all
appliance and ancillary parts must be regularly,
and after every use, cleaned free of fruit pulp and
vegetable mash.
Note:
DO NOT use any aggressive cleaning agents to clean
the juice extractor. The appliance and its ancillaries
may not be cleaned in boiling water.
Warning:
To avoid receiving an electrical shock, NEVER
submerse the motor/appliance base
u
in water
or other fluids.
• Switch the appliance off at the On/Off switch
o
.
• Soiling or overflowing fruit juices should be cleared
away immediately, as fruit stains are difficult to
remove later.
• For cleaning the appliance housing and the power
cable, use a cloth that is only lightly moistened.
• Clean the stodger
q
, the separate juice collector
h
, the housing lid
e
and the container for fruit
pulp and vegetable mash
s
in warm soapy water
and then carefully rinse them off.
The stodger
q
, the juice container
t
, the housing
lid
e
, the separate juice collector
h
and the con-
tainer for fruit pulp and vegetable mash
s
are sui-
table for cleaning in a dishwasher and can be cle-
aned there. To clean the filter
d
, use the supplied
nylon brush
g
:
• Turn the lid of the stodger
q
until the arrow points
to the opened lock on the stodger shaft. You
can now remove it.
The nylon brush
g
is inside the stodger
q
. To
re-close the lid, place it on the stodger so that
the arrow points to the opened lock .
Then turn it until the arrow points at the closed
lock . The lid now sits firmly.
• Hold the filter
d
(with the underside upwards)
under running water and clean it with the nylon
brush
g
.
Colouring:
• Some fruits or vegetables could permanently dis-
colour parts of the juice extractor. This is not da-
maging and does not impair the appliance in its
functions.
IB_54374_SFE450A1_LB6.qxd 17.06.2010 15:23 Uhr Seite 6