Silvercrest SWK 3000 EDS A1 Hot Beverage Maker User Manual


 
- 3 -
ƽ
Warning
First remove the plug from the wall power socket before
you lift the kettle from the base 3. This avoids the
risk that any water splashing out could come into
contact with live electrical connections in the base 3,
which could cause a short circuit.
ƽ
Injury hazard
For safety reasons, the lid should not be opened
while the water is boiling or is very hot.
There is a risk of receiving severe scalds.
Cleaning and Care
ƽ
Danger
Do not open any part of the housing.
There are no user-servicable elements inside.
An open housing can create the risk of a lethal
electrical shock.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered
components.
ƽ
Risk of personal injuries
Before cleaning the appliance, remove the plug
from the mains power socket and allow the appliance
to cool down.
Clean the exterior surfaces and the power cord
with a slighly damp cloth. Be sure to dry the
appliance well before taking it back into use.
For stainless steel surfaces, you can use appropriate
cleaning agents from a specialized dealer.
Never use detergents, abrasive cleaners or solvents.
These can damage the appliance.
In the event of scale deposits:
Before descaling, remove the pourer sieve 5
(see chapter "Removing/replacing the pourer
sieve").
Obtain any decalcifying agent suitable for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a hardware shop. Proceed as detailed in
the instructions provided for the use of the
decalcfying agent.
Removing/replacing the pouring sieve
Open the lid.
Press the retainer at the top of the pourer sieve
5 down and, at the same time, pull the pourer
sieve 5 inwards.
Remove the pourer sieve 5.
Clean the pouring sieve 5 with a lightly
moistened dishcloth and under running water.
Replace the pourer sieve 5 after cleaning it.
Ensure that the retainer engages and that the
pourer sieve 5 is firmly seated.
Notice
Should the scale deposits in the pourer sieve 5 be
firmly established, lay it in a water-vinegar solution
having a ratio of 6:1 for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve 5 with lots of clear water.
Storage
Allow the appliance to cool off completely before
putting it into storage.
Wind the power cable around the cable retainer on
the underside of the base 3.
Store the appliance in a dry place.
IB_61662_SWK3000EDSA1_LB6 26.10.2010 14:49 Uhr Seite 3