Filter
Top Products
- 4 -
Heating water
ƽ
Danger
NEVER place the electrical base
y
adjacent to
water – a potentially fatal risk!
Note
Always use freshly drawn water. Do not consume
any water that has already stood in the kettle for
longer than one hour. Do not reboil water that has
cooled down. Always pour old water away.
Microbes could have formed in it!
Note
When possible, heat only as much water as you
actually need. This also saves energy!
• Lift the kettle off of the base when filling it!
• Open the lid by pressing the lid switch under the
handle of the lid
t
, thereby opening the lid up.
Pull the lid back slightly so that it is secure and
does not drop down.
• When filling it, hold the kettle upright . Only in
this way can you correctly read the markings.
Fill the kettle...
– at least to the MIN mark, so that the appliance
does not overheat,
– no more than to the MAX mark, so that no boiling
water spills out.
• First close the lid, ensuring that it engages...
• and then place the kettle on the base
y
, such
that it is standing absolutely upright on the base
y
.
• Insert the plug into a mains power socket.
You can now heat the water up:
• Set the desired temperature:
press the button SET TEMP
r
repeatedly until
the LED
q
at the desired temperature glows.
You can choose between 40°C, 60°C, 80°C
and 100°C.
Information
If you cannot set the desired temperature, it may be
because the temperature of the water in the kettle is
still too high. In this case, exchange the water for
freshly drawn mains water.
• When you selected the desired temperature,
press the On/Off button
e
within about 10 se-
conds. The LED
q
of the selected temperature
blinks. The LED integrated in the On/Off button
e
glows. If you do not start the boiling process wit-
hin 10 seconds the set temperature lapses.
• Once the desired temperature has been reached,
a signal tone sounds, the respective LED
q
for
the temperature reached is lit constantly for
about 2 minutes and the LED integrated in the
On/Off switch
e
extinguishes.
Information
If you want to bring water to a boil (100°C), you
only need to press the On/Off button
e
. The
kettle will bring the water to a boil.
Information
- You can cancel the heating up of the water at
any time by pressing the On/Off button
e
.
- Once you lift the kettle from the base
y
, the
appliance switches all functions off. All settings are
cancelled.