Silvercrest SWKG 3000 A1 Hot Beverage Maker User Manual


 
- 4 -
ƽ
Warning
Remove the power plug from the wall socket before
you take the kettle from the base
y
. This prevents
causing a potential short circuit by water possibly
spilling out of the carafe and falling onto live electrical
connections in the base
y
.
ƽ
Injury hazard
For safety reasons, the lid
w
should not be opened
while the water is boiling or is very hot. There is a
risk of receiving severe scalds.
Cleaning and Care
ƽ
Danger
Do not open any part of the housing. There are no
user-servicable elements inside. An open housing
can create the risk of a lethal electrical shock.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered com-
ponents.
Before cleaning the appliance, ....
first, remove the plug from the power socket and
allow the appliance to cool down completely.
Clean the exterior surfaces and the power cable
u
with a slightly damp cloth. Be sure to dry the
appliance well before taking it back into use.
Never use detergents, abrasive cleaners or
solvents. These can damage the appliance.
In the event of scale deposits:
Before descaling, remove the pourer sieve (see
chapter "Removing/replacing the pouring sieve").
Obtain any decalcifying agent suitable for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a hardware shop. Proceed as detailed in the
instructions provided for the use of the decalcfying
agent.
For cleaning the stainless steel container bottom
you can use a suitable product from a specialist
dealer .
Removing the lid
To make the cleaning of the appliance interior easier,
you can remove the lid
w
:
Open the lid
w
.
Press the lid
w
, as shown in the diagramme, to
the rear
q
.
You can then pull out the hinge and lift out the
lid
w
, as shown in the diagramme
w
.
On reassembly, ensure that the lid
w
is put in
the correct way round. The thickening at the frame
of the lid
w
must point upwards when it is being
replaced, and also the level surface of the frame
to the handle
r
. Otherwise, the lid
w
cannot
be closed!
w
q
IB_54368_SWKG3000A1_LB6 15.07.2010 17:05 Uhr Seite 4