Sirius Range Hoods SU1 Ventilation Hood User Manual


 
Re-Circulating Requirements
If the unit will be used in
re-circulating mode (refer Figure 11),
fit the deflector (refer Figure 12) with
the screws supplied to the upper
telescope chimney.
There are holes in the back upper
edge of the decorative chimney for
this purpose.
Figure 11 Figure 12
A short length of ducting is
connected between the exhaust
outlet on the fan and the deflector to
direct the air back into the kitchen
through the vents at the top of the
upper decorative chimney.
The carbon filter (supplied
separately) that absorbs odors is
installed behind the aluminium
grease filter (refer to Fig 13).
Please read all the instructions
before operating the appliance.
Save these instructions for
future reference.
General Advice
Ensure that the grease filters are in
place. Without these components,
operating blowers could catch on to
hair, fingers and loose clothing.
Keep fan, filters and surfaces clean
of grease and fat. Always turn hood
fan ON when cooking. NEVER leave
cooking unattended.
O P E R A T I N G P R O C E D U R E S
NEVER dispose cigarette ashes,
ignitable substances or any foreign
objects into blowers.
Cooking that generates flame is not
recommended as this hood is
equipped with a thermal overload
that will shut down the motor if it
senses excessive heat. When
frying, oil in the pan can easily
overheat and ignite. Heat oil slowly
in an appropriately sized pot
(covering the entire burner) to
reduce the risk of boiling over and
burning.
Figure 13
6