Filter
Top Products
Instructions for the installer
2. INSTALLATION OF THE APPLIANCE
The following operation requires building and/or carpentry work so must b
e
carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are hea
t
resistant (T 90°C).
2.1 Attachment to support structure
If you wish to install the appliance
on a work-top, the holes illustrated
by the grey areas in figure 1 must
be made in the top to allow this.
Make sure there is a minimum of
750 mm between the hot plate
flames and any shelf that may be
installed directly above them.
1
To fix the appliance to the worktop,
insert the 4 fixing brackets (A) as
shown in the diagram until they fit
securely into place.
Then use 4 self-tapping screws to
fix the appliance to the worktop
through the slots B.
2
2.2 Electrical connection
Make sure that the voltage and capacity of the power line conform to the
data shown on the plate located under the casing. Do not remove this
plate for any reason.
The plug on the end of the supply cable and the wall socket must be the
same type and conform to the current electrical system regulations.
Check that the power line is adequately grounded.
On the power line, install an omnipolar cut-off device with contact cut-off
distance greater than or equal to 3 mm, located in an easily accessible
position near the unit.
18