Filter
Top Products
Instructions for the installer
38
2.2 Ventilation requirements
The room containing the appliance should have an air supply in
accordance with B.S. 5440 part 2 1989.
1. All rooms require an opening window or equivalent, and some
rooms will require a permanent vent as well.
2. For room volumes up to 5 m
3
an air vent of 100 cm
2
is required.
3. If the room has a door that opens directly to the outside, and the
room exceeds 1 m
3
no air vent is required.
4. For room volumes between 5 m
3 3 2
and 10 m an air vent of 50 cm is
required.
5. If there are other fuel burning appliances in the same room B.S.
5440 part 2 1989 should be consulted to determine the air vent
requirements.
6. This appliance must not be installed in a bed sitting room of less
3
than 20 m or in a bathroom or shower room.
Windows and permanent vents should therefore not be blocked or
removed without first consulting a Corgi gas installer.
Failure to install appliances correctly is dangerous and could lead
to prosecution.
The room must be kept adequately ventilated to remove the heat and
humidity produced by cooking; after prolonged use in particular, open a
window or increase the speed of any fans installed.
2.3 Connecting to natural and LPG gas
(Please see connection diagram)
Make the connection to the appliance using
flexible bayonet style hose in accordance to B.S.
669. The hose connection at the rear of the
appliance has a 1/2" BSP internal thread. Please
use seal C between the flexible connection L and
the appliance supply tube B. When making the
connection, make sure that no stress of any kind
is applied to the cooker and that the hose does
not touch any sharp edges.
If connecting to LPG the bayonet hose must
have red bands on it.
When installation is complete, check for any
leaks with a soapy solution and never with a
naked flame.
Take care that the hose is not crushed or
damaged.