Filter
Top Products
Instructions for the installer
22
2. INSTALLATION OF THE OVEN
The oven must be set up on a perfectly flat surface and left standing
free. Make sure to allow enough room at the back for easy access to the
terminal strip for connection of the power cable to mains.
Installation must be carried out by a qualified technician in compliance
with applicable regulations in force.
2.1 Electrical connection
Make sure that the power line voltage matches the specifications
indicated on the rating plate located to the rear of the oven. This rating
plate must never be removed.
The oven is equipped with a power
converter which is designed to adapt
power input to local current rating.
The converter is factory-set at 3850W.
If required, this value may be
increased by adjusting the switch at
the rear of the oven by means of a
screwdriver.
MIN = Minimum power (3850W).
MED = Medium power (4250W).
MAX = Maximum power (5500W).
The connection terminals are
located at the rear of the
appliance. For electrical
connections see following
diagram. For access to the
terminal board, remove the
door located at the back of
the oven.