Filter
Top Products
Instructions for the installer
21
The power supply connector on the back of the oven may be used only
for supplying the optional extractor hood, which has maximum power
absorption of 300W.
2.1.1 Safety thermostat
The oven is fitted with a safety device which trips in case of serious
malfunction. To reset, contact the nearest servicing centre.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the oven.
2.2 Levelling
Adjust the four feet so as to set the oven on a perfectly level plane. For
this purpose, loosen the lock nut and unscrew the foot. The range of
adjustment of the screw is 10 mm.
2.3
Water line connection
Connect the water intake valve on the back to the water supply using a
hose with a ¾ gas thread, making sure that the connections are secured
tightly.
If the water hose is new or has not been used for a long period of time,
run the water to ensure that the water is clear and free of impurities
before you connect it. This is a precautionary measure serving to avoid
the risk of the water causing blockage and thus damaging the appliance.
You are advised to supply the oven with a water pressure ranging
between a minimum of 50 KPa and a maximum of 500 KPa.
An exhaust pipe is fitted on the top of the
oven to allow the discharge of steam
during cooking. Make sure that it's no
way obstructed.