Smeg ALFA41XE Oven User Manual


 
Instructions for the User
4.4 Fan mode cooking
Use the knob to select one of the preset programs (P1 - P5).
The display shows the parameters of the selected program (tc = cooking
time; temperature in degrees Centigrade and program number, e.g. P1).
Press START to confirm the start of the program.
The program starts, performing the preheating stage; the display shows
"PrEh".
When the preheating is complete, a "BEEP" sounds to indicate that
cooking can start.
Press START to start cooking.
(If START is not pressed after the beep, the temperature is held constant
for about 10 minutes, after which it will start to drop for a period up to a
maximum time of 20 minutes, counted from when the beep sounded. After
this the oven switches off. During this stage, the display shows the
parameters of the selected program).
N.B. –
although this is not recommended in terms of cooking quality, the
program can be started even before the preheating temperature is
reached by pressing START.
During cooking, the display shows the time left until the end of the cooking
process and the temperature set. During the last minute of cooking, the
display will only show the countdown from 60 to zero seconds (end of
cooking time). When all the cooking time has passed, a BEEP will sound
for 20 seconds and the display will show "End".
During these 20 seconds
the user can extend the cooking time as required,
in manual mode, as follows. Press START; the display will show "tp00".
From now on, each pressure on the START key corresponds to one more
minute's cooking; up to 10 extra minutes are permitted. Cooking will restart
at the programmed temperature after 5 seconds.
After these additional minutes, the program repeats the cooking end
procedure described above and after the 20-second BEEP the word "End"
will flash for 20 minutes, during which time the temperature will gradually
fall, stabilising at 100°C. After 20 minutes, the oven switches off.
4.5 Manual mode cooking
Use the knob to select the "easy" program ( *).
The special feature of this user-editable program is that the cooking
parameters set are not retained in the memory when the knob is turned to
any other position.
This means that an "empty" program is always immediately available for
quick, easy editing.
4.5.1 How to use this program
Use the knob to select the "easy" program (
*).
27