Filter
Top Products
Instructions for the installer
2. INSTALLATION OF THE APPLIANCE
Installation must be carried out by a qualified technician in compliance
with applicable regulations in force.
2.1 Positioning
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
2.1.1 Fixing
Insert screws A of the brackets provided into slots B under the appliance.
Slide the brackets into slots B. Position the appliance on to the support
frame and secure it by means of screws C.
To connect the appliance to the mains, holes have to be made in the
cabinet which vary from model to model. The diagram below shows the
dimensions of the three models and the distances from the edges at
which the hole (in grey) has to be made in each case.
Make sure there is a minimum of 750 mm between the hot plate flames
and any shelf that may be installed directly above them.
19