Filter
Top Products
Instructions for the user
54
Make sure you only use containers intended for induction cooking, with a thick and completely flat
bottom or, if not available, containers without a curved bottom (concave or convex).
YES NO NO
13.5.1Cookware detector signal
Every cooking zone has a “cookware detector” device that starts cooking only when there is a container
with the appropriate caracteristics on the burner and it is positioned correctly. If the container is not well
positioned or isn't made of the correct material and still tries to activate the burner, after a few seconds
from the burner's activation, the symbol will appear on the display.
13.5.2Residual heat
Each cooking zone is equipped with a residual heat warning device. After any burner is switched off, a
flashing may appear on the front zone. This warns that the cooking zone concerned is still very hot.
Cooking can be restarted even while the is flashing.
13.5.3Cooking hob lock-out
When not in use, the hob can be “locked” from being accidently turned on by children. With the burners
turned off, turn the knobs of burners 2 and 4 simultaneously until “5 L” appears on the power display.
Then release the knob. To unlock it repeat the same operation: The burners' displays will show a 0 that
will indicate that the burners' lock has been deactivated.
13.5.4Circuit board thermal protection
The appliance is provided with a device that constantly measures the temperature of the electronic
circuit board.
If the temperature surpasses certain values, the device will activate certain functions to lower the
temperature and allow the glass-ceramic hob to continue to work correctly.
Below is a table with the operations that are activated automatically and the relative start temperature: