Filter
Top Products
Instructions for the installer
14
5.2 Regulation for LPG
Loosen screw A and push support B all the way. Use a double head
wrench to remove nozzle C and assemble the suitable one, following the
instructions indicated in the reference charts, with respect to the type of
gas to use. The screwing torque of the nozzle should never exceed 3
Nm. Reposition support B so that nozzle C is covered perfectly. Place the
burner on its support and ignite it. Move the Venturi tube D to regulate the
air flow until the flame is stable and burns regularly, then secure the tube
by means of screw A.
Burner
ULPG – 2.75 kPa
Nominal gas consumption
(MJ/h)
Injector
(mm)
Auxiliary (1) 4.8 0.60
Semi-rapid (2) 6.0 0.68
Rapid (3) 12.5 0.95
internal (4) 3.8 0.48
Double crown
external (4) 14.4 0.98