Smeg CO170 Refrigerator User Manual


 
INSTRUCTIONS FOR USE
GB
3.The green LED (if provided) is off and the appliance is
not working.
Is there a power failure?
Is the plug properly inserted in the socket?
Is the electric cable intact?
4.The green LED (if provided) is off and the appliance is
working.
The green LED is not working. Contact the After Sales
Service for a replacement.
5.The compressor runs continuously.
Have hot foods been put in the appliance?
Has the appliance lid been left open for a long time?
Is the appliance placed in a very warm room or near heat
sources?
Is the thermostat setting correct?
Has the fast freeze function (depending on model) been
pressed by mistake?
6.Too much ice on the upper edge.
Are the defrost water drainage plugs correctly positioned?
Is the appliance lid properly closed?
Is the appliance lid seal damaged or deformed? (See chapter
“Installation”)
Have the 4 protection pieces been removed? (See chapter
“Installation”)
7.Formation of condensate on the external walls of the
appliance.
It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated room.
The performance of the appliance is in no way affected.
8.The layer of ice on the internal walls of the appliance
is not uniform.
This phenomenon is quite normal.
SAFEGUARDING THE ENVIRONMENT
1.Packing
The packaging material is entirely recyclable, and marked with
the recycling symbol. Follow local regulations for scrapping.
Keep the packaging materials (plastic bags, polystyrene parts,
etc.) out of reach of children, as they are potentially dangerous.
2.Scrapping
The appliance is manufactured using recyclable material .
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it shall be handed
over to the applicable collection point for the recycling of
electrical and electronic equipment.
Before scrapping, make the appliance unusable by cutting off
the power cable and removing the doors and shelves so that
children cannot easily climb inside the appliance.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. Deliver the
appliance immediately to an authorized dump; do not leave it
unattended even for a few days, since it is potentiallydangerous
for children. For more detailed information about treatment,
recovery and recycling of this product, please contact your
local city office, your household waste disposal service or the
shop where you purchased the product.
Information:
This appliance does not contain CFCs. The refrigerant circuit
contains R134a (HFCs) or R600a (HCs), see the rating plate
inside the appliance.
Appliances with Isobutane (R600a):
Isobutane is a natural gas with low environmental impact.
Caution is required, however, since isobutane is flammable.
Therefore, it is essential to ensure that refrigerant pipelines
are not damaged.
This product contains Fluorinated Greenhouse Gases
covered by the Kyoto Protocol, the refrigerant gas being in a
hermetically sealed system. Refrigerant gas: R134a has a
Global Warming Potential (GWP) 1300.
Declaration of conformity
This appliance is designed to store food and is manufactured in
conformity with European Directive 90/128/EEC, 02/72/EEC
and Regulation (EC) No. 1935/2004
Thisappliance is designed, manufactured, and retailed in
compliance with:
- the safety objectives prescribed in the Low Voltage
Directive 2006/95/CE (which replaced Directive
73/23/CEE as amended);
- the protection requirements of the "EMC" Directive
89/336/EEC amended by Directive 93/68/EEC.
The electrical safety of the appliance can only be guaranteed if
the product is connected to an approved earth connection.
AFTER-SALES SERVICE
Before calling out an After-sales Service technician,
make sure that:
1.
the plug is properly inserted in the socket;
2.
the mains electrical supply is present;
3.
the meter box safety switch has not tripped;
4.
the power supply voltage corresponds to that indicated
on the appliance;
5.
if the problem persists, contact the After-sales Service,
tel. 199.135.135 * (in contact with your local area
Technician).
Before calling the After-sales Service, be sure to have
the following information ready:
your full address and telephone number;
the appliance model;
the serial number (“S/N”) of the appliance, indicated on
the accompanying documentation and on the data plate on
the rear of the unit;
the nature of the fault.
* Maximum cost 14 cents/min (VAT included) without connection charge
from landlines. Average cost 39 cents/min (VAT included) and maximum
connection charge of 15 cents (VAT included) from mobile networks.
For further details on mobile charges, contact your network operator.