INSTRUCTIONS FOR USE
GB
3.The green LED (if provided) is off and the appliance is
not working.
•
Is there a power failure?
•
Is the plug properly inserted in the socket?
•
Is the electric cable intact?
4.The green LED (if provided) is off and the appliance is
working.
•
The green LED is not working. Contact the After Sales
Service for a replacement.
5.The compressor runs continuously.
•
Have hot foods been put in the appliance?
•
Has the appliance lid been left open for a long time?
•
Is the appliance positioned in a very warm room or near
heat sources?
•
Is the thermostat setting correct?
•
Has the fast freeze function (depending on model) been
pressed by mistake?
6.Too much ice on the upper edge.
•
Are the defrost water drainage plugs correctly positioned?
•
Is the appliance lid properly closed?
•
Is the appliance lid seal damaged or deformed? (See chapter
“Installation”)
•
Have the 4 protection pieces been removed? (See chapter
“Installation”)
7.Condensation forms on the external walls of the
appliance
•
It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated room.
The performance of the appliance is in no way affected.
8.The layer of ice on the internal walls of the appliance
is not uniform.
•
This phenomenon is quite normal.
SAFEGUARDING THE ENVIRONMENT
1.Packing
The packaging material is entirely recyclable, and marked with
the recycling symbol. Follow local regulations for scrapping.
Keep the packaging materials (plastic bags, polystyrene parts,
etc.) out of reach of children, as they are potentially dangerous.
2.Scrapping
The appliance is manufactured using recyclable material .
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you can help
prevent potential damaging consequences for the
environment and human health.
The symbol on the appliance, or on the accompanying
documents, indicates that this appliance should not be
treated as household waste, but must taken instead to a
suitable collection point for the recycling of electrical and
electronic equipment.
Before scrapping, make the appliance unusable by cutting off
the power cable and removing the doors and shelves so that
children cannot easily climb inside the appliance.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. Deliver the
appliance immediately to an authorized dump; do not leave it
unattended even for a few days, since it is potentially dangerous
for children. For more detailed information about treatment,
recovery and recycling of this product, please contact your
competent local authority, your household waste disposal
service or the shop where you purchased the appliance.
Information:
This appliance does not contain CFCs. The refrigerant circuit
contains R134a (HFCs) or R600a (HCs), see the rating plate
inside the appliance.
Appliances with Isobutane (R600a):
Isobutane is a natural gas with low environmental impact.
Caution is required, however, since isobutane is flammable.
Therefore, it is essential to ensure that refrigerant pipelines
are not damaged.
This product contains Fluorinated Greenhouse Gases
covered by the Kyoto Protocol, the refrigerant gas being in a
hermetically sealed system. Refrigerant gas: R134a has a
Global Warming Potential (GWP) 1300.
Declaration of conformity
•
This appliance is designed to store food and is manufactured
in conformity with European Directive 90/128/EEC,
02/72/EEC and Regulation (EC) No. 1935/2004
•
Thisappliance is designed, manufactured, and retailed in
compliance with:
- the safety objectives prescribed in the Low Voltage
Directive 2006/95/CE (which replaced Directive
73/23/CEE as amended);
- the protection requirements of the "EMC" Directive
89/336/EEC amended by Directive 93/68/EEC.
•
The electrical safety of the appliance can only be
guaranteed if the product is connected to an approved
earth connection.
AFTER-SALES SERVICE
Before calling out an After-sales Service technician,
make sure that:
1.
the plug is properly inserted in the socket;
2.
the mains electrical supply is present;
3.
the meter box safety switch has not tripped;
4.
the power supply voltage corresponds to that indicated
on the appliance;
5.
if the problem persists, contact the After-sales Service,
tel. 199.135.135 * (in contact with your local area
Technician).
Before calling the After-sales Service, be sure to have
the following information ready:
•
your full address and telephone number;
•
the appliance model;
•
the serial number (“S/N”) of the appliance, indicated on
the accompanying documentation and on the data plate on
the rear of the unit;
•
the nature of the fault.
* Maximum cost 14 cents/min (VAT included) without connection charge
from landlines. Average cost 39 cents/min (VAT included) and maximum
connection charge of 15 cents (VAT included) from mobile networks.
For further details on mobile charges, contact your network operator.