Filter
Top Products
Instructions for the User
59
Before starting the automatic cleaning cycle, make sure that the oven does not contain any foods or
large spills from previous cooking operations inside.
A door interlock device means that the door cannot be opened during the procedure.
If the oven is installed underneath a hob, make sure that the burners or electric plates remain off during
the automatic cleaning cycle.
12.7 Before starting the automatic cleaning cycle
Pyrolysis may be carried out at any time of the day or night (if you wish to benefit from the lower cost of
electricity overnight).
• only the baking tray, the oven tray and the roof liner may be left inside the oven since they will
withstand the high temperatures of the pyrolysis process; all the other accessories must be removed
from inside the oven.
• remove the most obvious dirt (cleaning it by Pyrolysis would take too long);
• make sure that the oven door is firmly closed;
• when setting the cleaning cycle duration, refer to the chart below:
LIGHT DIRT MEDIUM DIRT HEAVY DIRT
CLEANING DURATION: 90 MIN. 105 MIN. 120 MIN.
During the first automatic cleaning cycle unpleasant smells may occur due to the normal evaporation of
oily manufacturing substances. This is an absolutely normal phenomenon which disappears after the
first cleaning cycle.
During the automatic cleaning cycle the fans make more noise because they are running at higher
speed. This is an absolutely normal function, intended to provide more effective heat dispersal. At the
end of the pyrolysis process the fans continue to run automatically for long enough to prevent
overheating of the sides of the cabinet and the front of the oven.
12.8 Setting the automatic cleaning cycle
Turn the function selector knob to the symbol to start the pyrolysis cycle. The orange thermostat light
comes on, followed a few minutes later by the red “door interlock” light to indicate that the appliance's
door has been locked because of the high temperature inside the oven. As soon as the function selector
knob is turned to , the display shows to indicate that the pyrolysis cycle will start immediately
and will last an hour and a half. The duration of the pyrolysis cycle can be increased up to a maximum of
3 hours. To do this, after the pyrolysis cycle starts press the key followed within a few seconds by the
value modification keys or . A few seconds after the last key is pressed, the display will show the
letter P followed by the pyrolysis duration just set, and the letter A will stop flashing. After starting the
pyrolysis procedure, and modifying its duration as just described if required, the cleaning cycle end time
can also be programmed.
Press button . The letter A will flash on the display, which will also show the sum of the current time
plus the duration of the pyrolysis cycle (e.g.: Current time: 12.10 - Programmed duration: 2.00 - Figure
shown: 14.10). At this point, the value modification keys or can be used to set the cleaning cycle
end time. A few seconds after the last key is pressed, the display will show the current time and the
orange light will go out; it will come back on at the preset time.
Warning: do not leave anything in the oven during the pyrolysis cycle. Keep children at a safe distance
and take care, especially if the cycle is set to start with a delay.
Use of the hob is not permitted during the pyrolysis cycle.