Filter
Top Products
6
DISPOSAL OF THE
APPLIANCE
The appliance contains recyclable
materials. When disposing of the
appliance, please contact the technical
administration or other appropriate
authority in your municipality. They
can inform you of the collection and
recycling measures used in the
municipality.
The dimensions for building in are noted on
the drawings.
It is safest to place the earthed wall socket
above the appliance and at least 2.0 m
above the floor.
Any local installation rules for appliances of
this kind must be observed.
During a storm the electricity supply might be
cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not immediately
observe that the power has been cut off.
Construction and details in the accessories
are subject to alteration without previous
notice.
If the cabinet is to be adjusted:
See drawings (1) page 20.
Take hold of the front panel with both hands.
Then lift up the front panel and turn out the
bottom part.
Adjust the tilt of the unit
See drawings (1) page 20.
by turning the adjustable feet with a 13 mm
spanner.
Adjusting the door
See drawings (1) page 20.
If the door bumps against the bottom panel,
this can be remedied by adjusting the feet as
shown on the drawing.
9. CHANGE OF HINGE SIDE
See drawings page 22.
1) Dismantle the top hinge. This one is to be
used later as top hinge at the opposite
side. Lift off the top door.
2) Remove the kick panel.
The bottom hinge is dismounted at the 3
screws. The hinge is turned 180° and
mounted
on the opposite side.
3) Adjusting the bottom door: Loosen the 3
screws in the bottom hinge and push the
bottom hinge to the required side. Tighten
the screws and mount the kick panel.
4)
The kick panel is mounted and the hole
plugs are mounted on the opposite side.
5) Ajustment of the top door: loosen the
screws in the hinge above the door,
loosen the hinge above the door and turn
the hinge to the wanted side. Tighten the
screws.
6) Move the handle.