Smeg CW350BS Dishwasher User Manual


 
13
Once draining has been completed the machine goes
into standby, indicated by the appearance of dashes “---
“ upon the display. Turn the machine back on by
pressing
and afterwards press the button. The
regeneration cycle starts and moving dashes appear on
the display; after 20 minutes the regeneration cycle
ends and the machine goes into standby. Open the
door, insert the overflow into the Tank and turn off the
main wall switch.
During the execution of the regeneration cycle it will not be possible to perform any operations. It must always be
done with the Tank empty.
Refilling the supply of regenerating salt (for models equipped with water softeners)
The refill is to be performed once the insufficient salt indicator appears on the display (
).
Perform the salt refill when there is no water in the Tank in order to keep wash water from entering the water
softener device.
Caution: Use only specific salt. Do not use table salt.
The salt tank has a capacity of about 1 kg of granulated salt.
The tank is situated at the bottom of the Tank. After having extracted the basket, unscrew the cap and pour the salt
through the provided funnel. Before screwing the cap back in place remove any eventual salt residues in proximity
to the opening.
8.5 Total drainage at the end of the day
The dishwasher is capable of performing an auto-clean cycle at the end of the day.
After having removed the overflow from the Tank, keep
the
button pressed for 3 seconds to initiate the
emptying of the Tank and boiler. The boiler door must
be closed while that of the Tank is to remain open. This
will inhibit water from loading and, after the Pressostat’s
Tank empty signal is given, will only allow a limited
amount of water from the boiler to circulate in order to
facilitate the cleaning of the Tank.
At the end of the function the machine goes into
standby, indicated by the appearance of dashes “---“ on
the displays. To render the machine operative again it
is therefore necessary to insert the overflow in the Tank
and press the
button. If the machine is equipped
with the drain pump option, the drain pump will activate
as well.
Do not turn off the washing machine while the Tank is full. Always drain it first.