Filter
Top Products
User instructions
INTERRUPTING A PROGRAM
In order to interrupt a running program it is necessary:
• to press the
START/STOP (5)
for some seconds until when the
writting “
Time to end
” remains lit on the display (confirmation beep).
At this point,it is possible to start the cycle again, otherwise:
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “
I
NTERRUPTING A PROGRAM
”);
• select the new program;
• to press again the
START/STOP
button
(5)
to make start the new
program.
STOPPING A PROGRAM
To stop a program in progress, it must first be interrupted (see
"
I
NTERRUPTING A PROGRAM
").
Now press buttons
P1
+
P2
simultaneously and
the first three program lights will come on.
The display will show "
P0
" and the dishwasher will immediately switch to
the end of the cycle and drain the tank (during this process, the "
Time to
end
" message will flash). When the drain procedure ends, the end of
cycle message "
End
" appears on the display.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TART PROGRAM
”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open or
not properly closed.