Filter
Top Products
User instructions
31
START PROGRAM
At this point, in order to start the machine, it is only enough to press the
START/PAUSE (6)
for
some seconds until the writtin “
Time to end
” start to flash and confirmation “beep” is heard. From
this moment the cycle dration on the
DISPLAY (9)
starts to decrease.
This phase, that updates itself during the cycle, is “indicative” since it is influenced by the washing
conditions such as dishwasher type and quantity, entry temperature etc. For this reason it is normal
to see the updating during a program (increment and decrease of minutes) specially in the passage
from one phase to the other (for example, from washing to rinse).
END PROGRAM
The end of the program is indicated by a short signal acoustic and from the “
End
” visual notification
on
DISPLAY (9)
. By pressing one of the buttons, the “
End
” visual signal will vanish from the
display and the dishwasher is ready to continue a new cycle, the same thing happens when closing
or opening the door or by switching on-off the machine.
INTERRUPTING A PROGRAM
In order to interrupt a running program it is necessary:
•
to press the
START/STOP (6)
for some seconds until when the writting “
Time to end
” remains
lit on the display (confirmation beep). At this point,it is possible to start the cycle again,
otherwise:
TO CHANGE A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see “
I
NTERRUPTING A PROGRAM
”);
•
select the new program;
•
to press again the
START/STOP
button
(6)
to make start the new program.
STOPPING A PROGRAM
To stop a program in progress, it must first be interrupted (see "
I
NTERRUPTING A PROGRAM
").
Now press buttons
P1
+
P2
simultaneously and the first three program
lights will come on.
The display will show "
P0
" and the dishwasher will immediately switch to the end of the cycle and
drain the tank (during this process, the "
Time to end
" message will flash).
When the drain procedure ends, the end of cycle message "
End
" appears on the display.
In case that the door is opened during the operation, to the next door closing it is going to be
necessary to start the program as shown in paragraph “
S
TART PROGRAM
”. The program will resume
from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start 30 seconds later
the door closing (this, in order to avoid overpressure phenomenom inside the tub).