Filter
Top Products
User instructions
32
CANCELLING THE CURRENT PROGRAM
To cancel the currently selected program, press the
START/STOP (5)
button for a few seconds,
until the active program appears on the
INFORMATION DISPLAY (4)
. At this point, to halt the
program in progress simultaneously press the
HALF LOAD (3)
button and the
START/STOP (5)
button. The
INFORMATION DISPLAY (4)
will show the letter
P
followed by a dash
(P-)
and the
dishwasher will automatically advance to the end of cycle.
CHANGING THE PROGRAM
To change the program, press and hold down the
START/STOP (5)
button for a few seconds, then
select the new program as described previously in the instructions; press the
START/STOP (5)
button again, holding it down for a few seconds.
DELAYED START
The start of the program can be delayed by 2, 4, 6, 8, 10 or 12 hours. In this way, it is possible to
run the dishwasher when most convenient.
Turn the
ON/OFF (1)
selector until appears on the
INDICATOR DISC (2)
the number of hours by
which the start of the washing program is to be delayed. This information automatically appears on
the
INFORMATION DISPLAY (4)
as well. Then proceed to select the program in the manner
described previously: the dishwasher will immediately perform a pre-wash cycle, and then
automatically initiate the countdown of the delayed start programmed; the
INFORMATION
DISPLAY (4)
will show a blinking clock symbol and the time remaining to the start of the program.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher
fully loaded
.
•
Do not wash the dishes in running water.
•
Use the washing program that is
most appropriate
for each type of load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
•
When possible,
disable the drying cycle
and leave the door open at the end of the washing
cycle: the residual air and heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
•
separate
the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
•
do not pour
the detergent directly on the dishes.
REMOVING THE DISHES
At the end of the washing program, wait at least
20 minutes
before removing the dishes, to allow
them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in
the lower basket, it is
advisable
to unload the lower basket first, and then the upper basket.