Filter
Top Products
18 19
Replacing Freezer Door
2
Insert the bottom hole of freezer door
straight to the bottom hinge pin.
1
Insert the water tube into the hole of the
bottom hinge pin first (Dispenser
Models Only). Insert the bottom of
freezer door into the bottom hinge pin.
3
Let the top of door close to the
cabinet and insert the top hinge pin
to the top hole of freezer door.
( Insert the back of hinge to the
groove of protrusion first, then front
to the top hole of door.)
4
Turn the hinge fastener tightly to the
end.
Connect harness wirings and screw
ground wire.
5
Insert the water tube far into the
coupling.
(Dispenser Models Only)
2
Let the top of door close to the
cabinet and insert the top hinge pin to
the top hole of freezer door.
( Insert the back of hinge to the
groove of protrusion first, then front
to the top hole of door.)
1
Insert the bottom hole of refrigerator
door straight to the bottom hinge pin
3
Turn the hinge fastener tightly to the
end.
Connect harness wirings and screw
ground wire.
Click and screw the top hinge cover.
Replacing Refrigerator Door
Insert a screw driver (flat tip) into a groove of the right wheel
(bottom of refrigerator) and turn it clockwise until the door is balanced.
(clockwise to raise refrigerator door ; counterclockwise to lower)
In case refrigerator door is lower than freezer door...
After installation and/or door leveling, fasten front cover with screws.
(Remove the screws on the front bottom panel first. Click and screw the cover)
Front Cover
Refrigerator Leveling & Door
Adjustment ( If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
Insert a screw driver (flat tip) into a groove of the left wheel
(bottom of freezer) and turn it clockwise until the door is balanced.
(clockwise to raise freezer door ; counterclockwise to lower)
In case freezer door is lower than refrigerator door...
● The front of refrigerator needs to be higher just a little than the back for easy door
closing, but if the wheel is raised too much for door balance, i.e. front of
refrigerator is higher than the back, it can be difficult to open the door.
Caution
!
!
@
!
!
@