Smeg FA550X Refrigerator User Manual


 
23
WATER CONNECTION
Disconnect the appliance from the mains power
supply before starting operations.
The ice maker and water circuit must be connected to a
water supply of potable and/or chemically purified water.
The water connection must be carried out in compliance
with local regulations.
The appliance is supplied with a water tube, 2.330 m. long,
already attached to the back of the product, and is provided
with a transition connector for connecting to the water
supply (internal bag).
Remove the shipping tape from the gray coiled water tubing
on the rear of the appliance.
Remove the protective cap from the end of the gray water
tubing.
Connect the water tube (1) to the transition connector (2).
Finger tightening and then 1 to 2 additional turns should be
adequate.
Connect the transition connector (2) to the household
water supply (3).
Make sure that the water tube is not twisted.
The appliance is pre-set for operation at pressures between
1.7 and 8.1 bar (25 and 117 PSI).
Open the water tap. Check for and eliminate any leaks.
The appliance does not require any adjustment or water
drain.
6gb33032.fm5 Page 23 Monday, May 23, 2005 2:17 PM