Filter
Top Products
6565
GB
of the appliance body and any furniture that
may be above it (fig. 5). If this requirement
is not followed, the appliance consumes more
electrical energy and its compressor may
overheat.
• If the appliance is placed in a corner, a
gap of at least 1 cm must be left between the
appliance body and the wall so that the freezer
compartment door can be opened enough to
pull out the frozen product drawer (fig. 6).
• The appliance must stand on a level surface
and must not touch the wall. If necessary,
regulate the height of the appliance by adjusting
the levelling feet 25 (fig. 1): by turning them
clockwise – the front of the appliance rises,
by turning them counter clockwise – it comes
down. If the appliance is tilted slightly backward
– the doors will close by themselves.
CONNECTION TO THE MAINS
WARNING! The appliance must be
plugged in to an earthed electricity supply
socket.
• The frequency and power of the electricity
supply in your house must conform to the
general data parameters of the appliance as it
is shown in the table (see page 63).
• When positioning the appliance, be careful
that the electrical cord isn’t squeezed in order
to avoid its damage. This can cause a short
circuit and a fire.
• Make sure that the plug of the electrical
cord is not squeezed by the back wall of the
appliance or otherwise damaged. A damaged
plug can be the cause of a fire!
• When unplugging the appliance, do not
touch the plug pins of the electrical cord.
CHANGING THE INTERIOR LIGHT
BULB
When changing the interior light bulb (fig. 7),
do the actions below in the order they are
listed:
1. Unplug the appliance from the mains by
pulling the plug out of the electricity supply
socket.
2. Squeeze the sides of the light fixture cover
1 to unhook the cover fasteners A and pull
downward. Remove the cover.
3. Replace the light bulb with the same 15 W
type light bulb with the E14 lamp holder.
4. After changing the light bulb, put the cover
fastener hook in place B and then press upward
until its fixing in place.
5. Plug the appliance into the electricity supply
socket.
CHANGING THE OPENING
DIRECTION OF THE DOORS
It is recommended that changing the opening
direction of the doors should be done with a
helper. You will need two spanners No. 8 and
No. 10 and a Philips head screwdriver.
! When changing the opening direction of
the doors, YOU CAN NOT lay the refrigerator
horizontally. Do the actions below in the order
they are listed (fig. 8):
WARNING! Turn off the appliance and
pull the plug out of the electricity supply
socket.
1. Remove the covers c from the body of the
refrigerator and of the inner side of the door.
Also remove the upper bracket 6 together with
the nut and washers and the spacer under the
bracket.
2. Remove the door of the refrigeration
compartment. Remove the stopper 5 from the
bottom of it. On the other side of the door,
attach the stopper intended for doors that open
on the left (you will find it in the packet).
3. Remove the middle bracket 4 together
with the washers on the axle and the plastic
spacer.
4. Remove the freezer compartment door 3.
5. Remove the bottom cover 1.
6. Remove the bottom bracket 2 together with
the washers on the axle and the plastic spacer.
Unscrew the axle with the washers and
screw it into the aperture provided on the other
side.
7. Remove the bottom bracket 7 and in its place
attach the other bottom bracket 2 together with
the washers on the axle and the plastic spacer.
Fix this bracket 7 in place of the other bracket 2.
8. Remove the covers 8 from the partition
separating the refrigeration compartment from