Filter
Top Products
UK - 3 -
Installation and Switching On The Appliance
This appliance is connecting to 220-240V and 50 Hz.
You can offer help from the service to install and switching on the appliance without
any cost.
Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
If the socket does not match the refrigerator plug, replace the plug with a suatible
one (at least 16 A)
Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact, we suggest you call an electrician for assistance.
Manufacturer is not responsible for failure to complete the ground connection as
described in this booklet.
Do not place the appliance in direct sunlight.
Do not use in open air and shall not be exposed to the rain.
Place the refrigerator far from heat sources and in a well-venti-
lated position. The refrigerator should be at least 50 cm from
radiators,gas or coal stoves and 5 cm far from electrical stoves.
Keep the top free for at least 15 cm.
Do not place heavy and lots of things on the appliance.
If the appliance is installed next to another refrigerator or freezer,
observe a miminum distance of 2 cm to prevent condensation.
Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good per-
formance.
The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap; the inside
of the appliance with sodium bicarbonate dissolved in luke-
warm water. After drying replace all the accessories.
Supply cable must be changet by technical supporters.
Before Switching On
Wait after 3 hours before plugging the appliance in to the main power
to ensure proper performance.
There can be an odor when you first switch on the appliance. It will
disappear after the appliance starts to cool.