Filter
Top Products
21
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.
See if you can solve the problem yourself with the
help of the “Troubleshooting guide”).
2.
Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the
appliance from the power supply and wait for
about an hour before switching on again.
3.
If the problem persists after this course of action,
contact After-sales Service.
Specify:
•
the nature of the problem,
•
the model,
•
the Service number (the number after the word
SERVICE on the rating plate on the inside of the
appliance),
•
your full address,
•
your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
INSTALLATION
ᕊ
Install the freezer away from heat sources.
Installation in a hot environment, direct exposure to the
sun or installation near heat sources (heaters, radiators,
cookers) will increase power consumption and should
therefore be avoided.
If this is not possible, the following minimum distances
must be respected:
30 cm from coal or paraffin stoves
3 cm from electric stoves.
• Install the appliance in a dry, well-ventilated place.
• Clean the interior (see “How to defrost and clean the
appliance”).
• Fit the accessories.
• Check the door seal is not damaged or deformed,
especially after installation or reversal of door opening.
Electrical connection
• Ensure that the voltage indicated on the appliance rating
plate corresponds to the domestic supply voltage.
• Regulations require that the appliance is earthed. The
Manufacturer declines all liabilities for injury to persons or
damage to property resulting from failure to observe these
regulations.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
• Do not use extension cables, multiple sockets or adapters.
ᕊ
60802006GB.fm Page 21 Monday, September 26, 2005 11:09 AM