Filter
Top Products
Important Safety Instruction
5
2. GENERAL INSTALLATION INSTRUCTIONS
• Proper installation is your responsibility. Have a qualified technician install this oven. Make sure
you have everything necessary for correct installation. It is responsibility of the installer to comply
with the installation clearances specified on the model/serial rating plate. The model/serial rating
plate can be found on the internal frame of the oven, once you open the door.
• Have your oven installed and properly grounded by a qualified installer, in accordance with
these installation instructions. Grounding is mandatory according to the provisions of the
electrical system safety regulations. If this appliance is connected to an outside electrical power
source, it must be grounded in compliance with local laws, or, if non exsist, in compliance with the
national ANSI / NFPA 70 code of electrical regulations.
• Make sure that the voltage and dimensions of the supply line correspond to the characteristics
indicated on the model/serial rating plate.
• Do not attempt to repair or replace any part of your oven unless it is specifically recommended in this
manual. All other service procedures should be performed by a qualified technician.
• This oven is not suitable for assembly and use in mobile homes or campers.
• Electrical grounding is required. See the “Make Electrical Connection” section. It is the customer’s
responsibility:
- To contact a qualified electrical installer,
- To ensure that the electrical system is adequate and in conformance with the national ANSI /
NFPA 70 ELECTRICAL CODE – Latest edition – Or the CSA STANDARDS C22.1-94,
CANADIAN ELECTRICAL CODE, PART 1 AND CSA C22.2 No. O-91 – or latest edition – and
all local codes and ordinances. IMPORTANT: Observe all governing codes and ordinances.