Filter
Top Products
35
Instructions for the installer
7.6 Electrical connection
Make sure that the voltage and capacity of the power line conform to the
data shown on the plate located under the casing.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a fixed connection is being used, fit the power line with an omnipolar
circuit breaker with a contact opening gap equal to or greater than 3 mm,
in an easily accessible position close to the appliance.
If a plug and socket connection is being used make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could
cause overheating and burns.
Operation at 220-240 V~: use an
H05V2V2-F type three-core cable
(3 x 0.75 mm
2
)
The end to be connected to the
appliance must be an earth wire
(yellow-green) at least 20 mm
longer.
The manufacturer declines all responsibility for damage to persons or
things caused by the non-observance of the above prescriptions or
deriving from tampering with any part of the appliance.