Filter
Top Products
User instructions
12
PROGRAMMING
All programming operations are only possible with the door closed.
To select a new program, the dishwasher must be in the "Program
start" state described above. Turn the PROGRAM SELECTOR (5) to
the program of your choice (see "PROGRAMS TABLE").
START PROGRAM
Press the START/PAUSE button (3) for a few seconds, until
the START/PAUSE light (4) starts to flash. A beep confirms
the operation.
PROGRAM SEQUENCE
For the entire duration of the program, ON/OFF (2) indicator
light remains permanently on, whereas the START/PAUSE
(4) indicator light flashes.
END PROGRAM
To indicate the end of the program, a short beep sounds
and the ON/OFF (2) and START/PAUSE (4) lights
illuminate simultaneously.
Before a new washing cycle can be selected the dishwasher
must be in "Program start" state: press the START/PAUSE
button (3) until the configuration of indicator lights (2) and
(4) is as follows.
INTERRUPTION OF A PROGRAM
Press the START/PAUSE button (3) for a few seconds, until
the configuration of the ON/OFF (2) and START/PAUSE (4)
lights is as follows.
You may now restart ("S
TART PROGRAM") or change the program which
was interrupted.