Filter
Top Products
User instructions
STARTING THE DISHWASHER
After carrying out all the operations described above correctly, to start the dishwasher simply press
the press the
START/PAUSE
button
(2)
for a few seconds until a beep sounds (the
PROGRAM
STARTED (5)
light starts to flash). The
3-FIGURE DISPLAY (6)
will show the duration of the
program in minutes. The duration time is only approximate, because it depends on the washing
conditions (quantity of dishes, water temperature, etc.), and is also continually updated as the
washing program progresses.
The
3-FIGURE DISPLAY (6)
shows the estimated duration of the washing program.
If it is necessary to open dishwasher door during the washing cycle, there will be a
1-minute delay
before the program can be resumed. After correctly closing the door, press the
START/PAUSE (2)
button
again
. This operation may negatively affective the progress of the washing cycle.
END OF CYCLE
At the end of the program the
PROGRAM STARTED (5)
light stops flashing and "
End
" appears on
the
3-FIGURE DISPLAY (6)
.
REMOVING THE DISHES
At the end of the washing program, wait at least
20 minutes
before removing the dishes, to allow
them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in
the lower basket, it is
advisable
to unload the lower basket first, and then the upper basket.