Filter
Top Products
User instructions
TABLE FOR CERTIFICATION BODIES
Reference standard EN 50242
Reference program
(*) Selector on
P4
Load 12 place-settings
Type of detergent B
Amount of detergent 30 g
Rinse aid setting Depending on the model 3/4 or 4/6
Washing programs
The dishwasher is equipped with a control panel and an
3-FIGURE DISPLAY (6)
, described in
chapter "1. Description of the controls", from which it is possible to carry out all the power switch-
on, switch-off and programming operations.
Before starting a washing program make sure that:
•
The water supply tap is
open.
•
The
correct amount of detergent
has been added to the
dispenser
.
•
The baskets have been
correctly loaded.
•
The spray arms are able to
rotate freely
and without obstruction.
•
The dishwasher door is
securely closed
.
HALF-LOAD FUNCTION (available in all programs except the soak program)
This function is recommended for loads of up to
6 place-settings
, and cuts down on the use of
water and electricity. It is controlled by the
HALF LOAD
button
(4)
and allows washing in the upper
basket only.
IMPORTANT:
at the end of the program remember
to deactivate the function
to ensure the next
wash is not also carried out in half load mode
by mistake
.
A cutlery basket can be placed in the
upper basket
, while the
lower basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the lower basket, since the jet of
water will only reach the upper basket.