Filter
Top Products
EN
1
9
19
USE
L
L1
T1
T2
T3
T4
L2
L3
L4
Control panel
Button Function Led
L Press briefly to turn the lighting system on and off.
Press and hold for approx. 2 seconds to turn the lighting system on and
off at reduced intensity.
-
T1 Turn the suction motor on and off at speed one.
If the filter saturation alarm is on, this resets it.
On.
T2 Turn the suction motor on at speed two.
If the filter saturation alarm is on, this resets it.
On.
T3 Press once to turn the suction motor on and off at speed three.
Press again to activate intensive speed. This speed is timed to run for
10 minutes. At the end of this time the system will automatically return
to the speed set before.
Suitable to deal with maximum levels of cooking fumes, it is deacti-
vated by pressing any one of the Speed buttons (T1-T2-T3).
It cannot be activated if the Delay function is in use.
If the filter saturation alarm is on, this resets it.
On.
Flashing.
T4
Activate automatic switch-off with a 30’ delay (Motor+Lights).
Suitable to complete elimination of residual odours.
Can be activated from any Speed, and is disabled by pressing the
button again or turning the motor off.
It cannot be activated if the Intensive function is in use.
If the filter saturation alarm is on, this resets it.
On.
Warning: The working hours of the motor are counted for the purpose of signalling filter saturation.
After 100 working hours all the LEDs (L1-L2-L3-L4) will light up and remain lit to indicate saturation of
the metal grease filters.
After 200 working hours all the LEDs (L1-L2-L3-L4) will light up and start to flash to indicate saturation
of the activated charcoal filters.