Filter
Top Products
12GB
220
15
264
L1
Vf
Hood Type 60 90
L 598 898
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING
• The hood support surface must be 220 mm
above the bottom surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided.
• Cut a hole ø 150 mm in size on the support
surface, using the drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provided.
SNAP-ON FITTING
• The hood can be installed either directly on the
bottom surface of the wall units (min. 650 mm
above the hob) using snap-on side supports.
• Cut a fitted opening in the bottom surface of
the wall unit, as shown.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.