Filter
Top Products
b. Drill a hole on the back and in the top of the cabinet for the
ventilation duct (a good rule of thumb is to make the diameter
of the hole 15 mm larger than that of the duct used).
c. Insert the C screws supplied with the hood into the F holes and
tighten the hood to the cabinet (Fig. 7).
Assembly using side bracket (if supplied)
The hood can also be mounted by means of two brackets supplied
with the hood. To fix the hood in this way (Fig. 8-9), proceed as
follows:
a. Drill two holes Ø 2 mm on the two sides of the cupboard from
the inside using the template Q supplied.
b. Fix the two brackets T to the upper side of the hood using
screws V 4,2 x 35 (the position of the brackets can be adjusted
in width according to the thickness of the cupboard panels).
c. Fix the hood, through the brackets already mounted, on the
inside of the cupboard using screws Z 3,5 x 13 (two each side).
Adjusting the Pull-Out Drawer
The hood can be installed beneath cabinets with varying depths.
Adjustments for opening and closing the drawer can be made
based on your specific needs.
To adjust the drawer, remove the ventilation grates by loosening
the M screws and adjusting the P brackets. Then retighten the M
screws (Fig. 10).
Using the hood
The hood is provided with several speeds. For the best performance,
we recommend using the low speeds in normal conditions and the
high speeds when strong odour and vapour concentrations are
present.
We recommend starting the hood a few minutes before cooking
and keeping it running for at least 15 minutes until all the odours
have been eliminated.
Maintenance
Caution! Before performing any maintenance, disconnect the
hood from the electrical supply.
Grease Filter
The grease filter serves to trap grease particles by suspending
them.
1. Synthetic Filter (thickness: 10-15 mm): wash the filter in
warm water and a biodegradable detergent once a month. Let
dry without wringing. Replace after the filter has been washed
5 or 6 times.
2. Thin Synthetic Filter (approximately 1 mm thick): replace
when the coloring from the top is visible on the bottom part.
3. Thin Synthetic Filter (approximately 1 mm thick - without
saturation indicator) replace every two months.
4. Metal Filter: unlimited life; wash every month in warm soapy
water, or, if possible, in the dishwasher (60°C). Let dry before
reinstalling it.
Removing the Grease Filters (for models wtih grease filter
support grates)
To remove the dirty grease filter, proceed as follows:
a) Remove the pull-out drawer completely and open the ventilation
grates that support the grease filters.
b) Remove the L fasteners for the grease filter and remove it (Fig.
11). If special metal filters have been installed, press on the
plastic springs (S) to unhook them (Fig. 4).
c) When washing or replacing the grease filter, wash the grate as
well with warm soapy water.
d) Remount the new filter or the old one after it has dried
thoroughly.
Charcoal Filter
The charcoal filter serves to eliminate odours that form during the
cooking process. Under normal use conditions, the filter should be
replaced every 4 months. It can be ordered from the retailer. The
charcoal filter must never be washed.
To remove the charcoal filter, proceed as follows:
a. Remove the pull-out drawer.
b. Remove the grease filters and open the light cover support (or
the greas filter support grate).
c. Turn the center knob on the charcoal filter in the
counterclockwise direction and remove the filter from its seat
(Fig. 6, in reverse).
Replacing the Lamp
a. Remove the pull-out drawer.
b. Open the light cover support or the back grease filter support
grate.
c. Replace the burned out lamp, using only 40W (max) olive-
shaped bulbs (E14).
d. Before calling for customer service because the lighting
system does not work, make sure that the lamps are screwed
in tightly.
Cleaning
The cooker hood should be cleaned regularly internally and
externally.
For cleaning use a cloth moistened with denatured alcohol or
neutral liquid detergents. Avoid abrasive detergents.
Warning:
Failure to carry out the basic standards of the cleaning of the
cooker hood and replacement of the filters may cause fire risks.
Therefore we recommend observing these instructions.
GB