Filter
Top Products
User instructions
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“
I
NTERRUPTION OF A PROGRAM
”).
Now press buttons
P1
+
P2
simultaneously and
the first three program lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TART PROGRAM
”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
DELAY PROGRAM
(on some models only)
(available in all programs except the soak program)
The
PROGRAM DELAY
button
(3)
can be pressed to delay the start of
the washing program by
3
,
6
or
9 hours.
This function allows you to set
the dishwasher to work at your preferred time of day.
After selecting the delay, start the program (see relative section).
The appliance will prewash the dishes, after which the "program delay"
set previously will come into effect (the light corresponding to
3, 6
or
9
hours
flashes).
To
reset or change the delay
once the program has started:
• press the
START/PAUSE
button
(4)
for a few seconds, until the
PHASES/PROGRAM
lights
(8)
come on;
• press the
DELAY PROGRAM
button
(3)
several times “until the
program delay” returns to zero (all the lights indicating the delay go
out);
• press the
START/PAUSE
button
(4)
to start the new program.